To Next PageTo Next Page
Need help?Do you have a question about the Mercury 175 Verado and is the answer not in the manual?
General| Displacement | 2.6L |
|---|---|
| Horsepower | 175 HP |
| Steering | Electro-hydraulic power steering |
| Gear Ratio | 1.85:1 |
| Cylinders | 6 |
| Fuel System | Electronic Fuel Injection (EFI) |
| Full Throttle RPM Range | 5800-6400 RPM |
| Fuel Induction System | Electronic Fuel Injection (EFI) |
| Shaft Length | 20" or 25" |
| Starting | Electric |
| Recommended Fuel | 87 Octane |
| Engine Type | 4-Stroke |
| Alternator Amp | 70 Amp |
Steps required for registering the product for warranty coverage in different regions.
Steps for initiating a warranty claim and arranging for product service.
Lists specific items, conditions, and uses excluded from warranty coverage.
Details of the specific limited warranty against corrosion failure.
Lists common items and situations not covered by the limited warranty.
Procedures for operating in shallow water or areas with potential underwater obstacles.
Steps and safety precautions for properly mounting the outboard motor.
Guidance on choosing the correct propeller for optimal performance and durability.
Proper procedures and safety precautions for trailering the boat and outboard.
Guidelines on acceptable gasoline types, octane ratings, and alcohol content.
Instructions and safety precautions for refueling the boat's fuel tank.
Recommended type, viscosity, and specifications for engine oil.
Procedure for checking and topping up the engine oil level.
Features and operation of panel-mounted remote control systems.
Describes warning horn sounds and their corresponding engine conditions.
Operation of the power trim and tilt system for adjusting outboard position.
How to use the power trim for optimal performance and safety.
Essential checks to perform before starting the engine.
Steps for properly breaking in a new engine to ensure longevity.
Step-by-step guide for starting the outboard motor correctly.
Procedures for shifting between forward, neutral, and reverse gears.
How to properly shut down the engine, including use of trim/tilt.
Recommended maintenance intervals and tasks for the outboard.
Detailed procedure for changing the engine oil and oil filter.
Procedures for preparing the outboard for out-of-season or prolonged storage.
How to prepare the fuel system with stabilizer for storage.
Possible causes and solutions for the starter motor not cranking the engine.
Common reasons and fixes for the engine failing to start.
