Mercury 275 VERADO - User Manual

i
Welcome Aboard!
Proper care and maintenance is an important part in keeping
your Mercury Product operating at peak efficiency for
maximum performance and economy. The enclosed Owner's
Registration Card is your key to trouble-free family fun. Refer
to your Operation and Maintenance Manual for full details
of your warranty coverage.
Details of your nearest dealer can be found on
www.marinepower.com where country maps and full
contact information are displayed.
Is your engine properly registered for warranty purpose?
Please check on www.marinepower.com. If necessary,
please contact your local dealer.
Declaration of Conformity
This outboard motor’s serial number plate contains in the
lower corner left hand corner either the CE mark alone or the
CE mark accompanied by a notified body number. This
outboard motor manufactured by Mercury Marine, Fond du
Lac, WI, USA or Marine Power Europe Inc. Park Industriel, de
Petit-Rechain, Belgium complies with the requirements of the
following directives by meeting the associated standards, as
amended:
If the CE mark is accompanied by a notified body number, the
following Recreational Craft Directive applies:
Recreational Craft Directive: 2003/44/EC amending 94/25/EC
Owner's manual (A.2.5) ISO 10240
Handling characteristics (A.4) ISO 8665
Outboard engine starting (A.5.1.4) ISO 11547
Fuel tanks (A.5.2.2) ISO 13591; ISO 8469
General steering system ABYC P-17
Exhaust emission requirements (B.
2)
ISO 8178
Owner's manual (B.4) ISO 8665
Noise emission levels (C.1) ISO 14509
© 2006 Mercury Marine 200/225/250/275 Verado (4-Stroke) 90-10237070 506

Mercury 275 VERADO Specifications

General

Engine Type	4-Stroke
Displacement	2.6 L
Horsepower	275 HP
Full Throttle RPM Range	5800-6400 RPM
Steering	Electro-hydraulic power steering
Shaft Length	25"
Dry Weight	635 lbs
Fuel Type	87 Octane
Starting System	Electric Start
Alternator Amp	70 Amp

Summary

Warranty Information

Transfer Of Warranty

Explains how to transfer the limited warranty to a subsequent purchaser.

Warranty Registration US and Canada

Details the process for registering the product for warranty in the US and Canada.

Warranty Registration Outside US and Canada

Describes warranty registration procedures for regions outside the US and Canada.

General Information

Boat Horsepower Capacity

Explains the importance of adhering to the boat's maximum horsepower limit.

Lanyard Stop Switch

Explains the function and operation of the lanyard stop switch for safety.

Impact With Underwater Hazards

Advises on reducing speed and caution in areas with suspected underwater obstacles.

Installation

Installing Outboard

Details the procedure for correctly mounting the outboard onto the boat transom.

Propeller Selection

Fuel and Oil

Fuel Recommendations

Specifies required fuel ratings and types, warning against leaded or improper gasoline.

Engine Oil Recommendations

Recommends specific NMMA FC-W certified synthetic blend oils for the outboard.

Checking and Adding Engine Oil

Details the procedure for checking and adding engine oil to ensure proper levels.

Features and Controls

Panel Mount Control Operation

Single Handle Console Control Operation

Slim Binnacle Control Operation

Dual Handle Console Control Operation

Dual Handle Control w;CAN Trackpad Operation

Warning System

Explains the various warning horn sounds and their corresponding descriptions.

Power Trim and Tilt

Describes the function and operation of the power trim and tilt system.

Operation

Pre-Starting Checklist

Engine Break-in Procedure

Details the correct procedure for breaking in a new engine to ensure longevity.

Starting The Engine

Gear Shifting

Maintenance

Selecting Replacement Parts

Inspection and Maintenance Schedule

Lists routine inspections and maintenance tasks required before and after use.

Maintenance Every 100 Hours or Annually

Details maintenance tasks to be performed every 100 hours of use or annually.

Maintenance Every 300 Hours or Three Years

Outlines maintenance tasks required every 300 hours of use or three years.

Flushing The Cooling System

DTS Battery Specifications

Fuel System

Corrosion Control Anode

Propeller Replacement

Provides step-by-step instructions for replacing the outboard propeller.

Spark Plug Inspection and Replacement

Details the procedure for inspecting, gapping, and replacing spark plugs.

Checking Power Trim Fluid

Checking Power Steering Fluid

Changing Engine Oil

Provides methods for changing engine oil, including pump and drain methods.

Gearcase Lubrication

Details procedures for draining, refilling, and checking gearcase lubricant.

Troubleshooting

Starter Motor Wont Crank Engine

Lists possible causes and solutions when the starter motor fails to crank the engine.

Engine Will Not Start

Provides potential causes and troubleshooting steps for an engine that won't start.

Engine Starts But Wont Shift Into Gear

Addresses issues where the engine starts but cannot be shifted into gear.

Engine Runs Erratically

Lists common causes for an engine running erratically and how to diagnose them.

Performance Loss

Battery Will Not Hold Charge

Owner Service Assistance

Local Repair Service

Service Assistance