2. Disconnect the wire from the bottom of the filter. Remove the filter (a) by
turning the filter in the direction of the arrow (clockwise). Tip the filter to
drain the fluid into a suitable container.
a - Water separating fuel filter
3. Lubricate the sealing ring on the filter with oil. Thread the filter into place.
Tighten it securely by hand. Connect the wire to the filter.
Fuses
IMPORTANT: Always carry spare 5, 15, and 20‑amp fuses.
The electrical wiring circuits on the engine are protected from overload by fuses
in the wiring. If a fuse is open, try to locate and correct the cause of the
overload. If the cause is not found, the fuse may open again.
1. Open the fuse holder and look at the silver colored band inside the fuse. If
the band is broken, replace the fuse.
2. Replace the fuse with a new fuse with the same rating.
To Next Page
Loading...
