Mercury 225 Pro XS - Special Tools and Kits

GENERAL INFORMATION
29
Description Specifications
Overspeed Rev Limit 6300 RPM
Engine Displacement 3032 cc (185 cu. in.)
Cylinder Bore 92.075 mm (3.625 in.)
Stroke 76.2 mm (3.000 in.)
Recommended Spark Plug NGK IZFR6J
Spark Plug Gap 0.81 mm (0.032 in.)
Firing Order 1‑2‑3‑4‑5‑6
Maximum Timing: Controlled by PCM
Idle Timing: Controlled by PCM
Fuel Line Pressure 655 ± 13.8 kPa (95 ± 2 psi)
Air Pressure 758 ± 13.8 kPa (110 ± 2 psi)
Gear Ratio
Torque Master (225 Pro
XS)
1.75:1
Sport Master (225 Sport
XS)
1.62:1
Required Fuel
Unleaded 87 R+M/2 octane (92
RON)
Recommended Oil Premium Plus TC‑W3 2‑Cycle
Gearcase Oil Hi‑Performance Gear Lube
Gearcase Lubricant Capacity 710 ml (24 fl oz)
Battery Rating
1000‑MCA (Marine Cranking Amps)
800‑CCA (Cold Cranking Amps)
105 Amp Hours
1.
Charging System Output 50 Amps Max.
NOTE: Where applicable, specifications are derived at sea level.
Special Tools and Kits
Description Part Number
Stainless Steel Tilt Pin 17‑49930A1
Flushing Attachment for Torque Master gearcase 44357T2
Dual Water Pick‑Up Flush Seal Kit for Torque Master gearcase 881150K1
1. Battery manufacturers may rate and test their batteries to different standards.
Consult with the specific battery manufacturer for comparison ratings.