STORAGE
100 eng
Flushing Device 91‑44357Q 2
Attaches to the water intakes;
provides a fresh water
connection when flushing the
cooling system or operating
the engine.
Protecting External Outboard Components
• Lubricate all outboard components listed in Maintenance ‑
Inspection and Maintenance Schedule.
• Touch up any paint nicks. See your dealer for touch‑up
paint.
• Spray Quicksilver or Mercury Precision Lubricants Corrosion
Guard on external metal surfaces (except corrosion control
anodes).
Tube
Ref No.
Description Where Used Part No.
120
Corrosion
Guard
External metal surfaces 92-802878 55
Protecting Internal Engine Components
NOTE: Make sure the fuel system has been prepared for
storage. Refer to
Fuel System
, preceding.
IMPORTANT: Refer to Maintenance ‑ Spark Plug Inspection and
Replacement for correct procedure for removing spark plug
boots.
• Place the outboard in water or connect flushing attachment
for circulating cooling water. Start the engine and let it run in
neutral to warm up.
To Next Page
Loading...
