INSTALLATION
38 eng
4. After positioning the clamp brackets, attach it with the clamp
screws then drill two holes in the transom board, matching
the holes in the clamp bracket. Secure the engine with the
supplied bolts and nuts. Be sure to use the washers.
a - Trim position pin
holes
b - Bolt
c - Clamp screw
d - Nut
TRANSOM MATCHING
NOTE: Be sure that the anti‑ventilation plate of the outboard is
below the water surface when running at wide‑open throttle. In
case the above condition cannot be met due to a bottom shape
of your boat, please consult the dealer.
Installing the Remote Control Device
RIGHT-HAND STEERING
1. Position the remote control box in a place that will not
obstruct handling of the control levers and switches. Confirm
there is no obstacle in the passage of the remote control
cables.
To Next Page
Loading...
