58
A Allow engine to cool down.
B Remove the water separating fuel filter. Refer to Changing Water Separating Fuel Filter.
C Pour out a small amount of fuel into a suitable container, then add approximately 2 fluid ounces (60 ml) of
Quicksilver 2-Cycle Outboard Oil to fuel in the water separating fuel filter.
D Reinstall water separating fuel filter.
E Disconnect harness connections from fuel pump and fuel boost pump.
F Start and operate engine at idle speed until the water separating fuel filter and fuel injection system are empty
and engine stops.
G Remove and discard water separating fuel filter.
H Install a new water separating fuel filter.
I Reconnect harness connections at both fuel pumps.
8 Clean flame arrestor. Refer to Cleaning Flame Arrestor and Related Components.
9 Lubricate all items listed in Lubrication section.
10 Drain seawater section of cooling system. Refer to Draining Instructions.
11 Test coolant to ensure that it will withstand the lowest temperature expected during storage.
12 Service batteries.
13 Clean outside of engine and repaint any areas required with Quicksilver Primer and Spray Paint. After paint
has dried, spray Quicksilver Corrosion and Rust Preventive Type II or wipe down with Quicksilver Storage
Seal or SAE 20W engine oil.
To Next Page
Loading...
Need help?
General