NOTE: To allow the oil to drain from the filter, loosen the filter just enough to
break the internal vacuum. Let the oil drain back into the system for 15
minutes prior to complete removal of the filter.
a - Crankcase oil filter
6. Remove the oil filter from the adapter and discard the old oil filter and old
sealing ring.
7. Coat the sealing ring on the new filter with motor oil and install a new
sealing ring and filter.
8. Tighten the filter securely. Do not overtighten.
9. Remove the oil filler cap. Add oil to bring the level up to, but not over, the
"FULL" mark on the dipstick.
IMPORTANT: Always use the dipstick to determine exactly how much oil is
required.
a - Crankcase oil filler cap
Tube Ref
No.
Description Where Used Part No.
25W-50 Synthetic
Blend 4-Stroke
Racing Engine Oil
Crankcase 8M0078013
CRANKCASE OIL AND FILTER (BOAT OUT OF THE WATER)
!
WARNING
Performing tests with the engine running may cause the propeller to rotate
and result in serious injury or death. Use caution when performing a test that
requires the engine running, and remove the propeller to avoid injury.
MAINTENANCE
56 eng
To Next Page
Loading...
Need help?
General