Mercury MerCruiser 5.0 TKS

© 2007 Mercury Marine 4.3 TKS, 5.0 TKS, 5.7 TKS Models
*899883179*
90-899883179 1007
NOTE: The following applies to CE marked products only.
Declaration of Conformance – Mercury MerCruiser
This sterndrive or inboard engine when installed in accordance to Mercury
MerCruisers’ instructions complies with the requirements of the following directives
by meeting the associated standards, as amended:
Recreational Craft Directive 94/25/EC; 2003/44/EC
Applicable Requirement Standards Applied
Owner’s manual (A.2.5) ISO 10240
Openings in Hull, Deck and superstructure (A.3.4) ISO 9093‑1; ISO 9093‑2
Handling characteristics (A.4) ISO 8665
Inboard Engine (A.5.1.1) ISO 15584; ISO 10088; ISO 7840; ISO 10133
Fuel System (A.5.2) ISO 10088; ISO 7840; ISO 8469
Electrical System (A.5.3) ISO 10133; ISO 8846
Steering system (A.5.4)
Applicable portions of: ISO 10592, ISO 8848 and
ABYC P‑17
Exhaust emission requirements (B.2) ISO 8178
Owner’s manual (B.4) ISO 8665
Noise emission levels (C.1) ISO 14509
Ignition‑protected equipment (Annex II) ISO 8846; SAE J1171; SAE J1191; SAE J 2031
Mercury MerCruiser declares that our sterndrive or inboard engines without integral
exhaust, when installed in a recreational craft, in accordance with the manufacturers
supplied instructions, will meet the exhaust emissions requirements of the directive
mentioned above. This engine must not be put into service until the recreational craft
in which it is to be installed has been declared in conformity, if so required, with the
relevant provision of the directive.
Electromagnetic Compatibility Directive 89/336/EC, 92/31/EEC and 93/68/EEC
Generic emission standard EN 50081‑1
Generic immunity standard EN 50082‑1
Vehicles, boats and internal combustion engine
driven devices ‑ Radio disturbance characteristics
SAE J551 (CISPR 12)
Electrostatic discharge testing EN 61000‑6‑2; EN 61000‑4‑2; EN61000‑4‑3
The notified body responsible for surveillance of the quality system under Full Quality Assurance
Module H of Directive 2003/44/EC is:
Det Norske Veritas
Norway
Notified Body Number: 0575
This declaration is issued under the sole responsibility of Mercury Marine and Mercury MerCruiser.
Patrick C. Mackey
President ‑ Mercury Marine, Fond du Lac, WI USA

Mercury MerCruiser 5.0 TKS Specifications

General

Engine Type	V8
Displacement	305 cu in (5.0 L)
Horsepower	220 hp
Compression Ratio	9.4:1
Starting System	Electric
Full Throttle RPM	4400-4800 RPM
Alternator	65 Amp
Ignition System	Electronic
Bore x Stroke	3.74 in x 3.48 in (95 mm x 88.4 mm)
Cooling System	Raw Water or Closed Cooling

Summary

Mercury MerCruiser Warranty Information

Mercury MerCruiser Limited Warranty

Details warranty coverage, duration, and terms for gasoline-fueled engines.

3-Year Limited Warranty Against Corrosion

Getting to Know Your Mercury MerCruiser Power Package

Lanyard Stop Switch

Describes the function and importance of the emergency engine kill switch and lanyard.

On the Water Operations

Safe Boating Suggestions

Provides essential tips for safe operation, including equipment, navigation, and passenger safety.

Carbon Monoxide Poisoning Awareness

Warns about the dangers of carbon monoxide and recommends ventilation measures.

Basic Boat Operation

Engine Starting and Stopping

20-Hour Break-In Period

Instructions for the critical engine break-in period to ensure performance and longevity.

Specifications and Requirements

Fuel Requirements

Specifies the correct type, octane rating, and alcohol content for gasoline.

Engine Oil Recommendations

Recommends specific engine oil types and viscosity grades for optimal performance.

Engine Specifications

Maintenance Procedures

Sterndrive Maintenance Schedule

Provides a detailed schedule for routine and scheduled maintenance tasks based on time or hours.

Changing Engine Oil and Filter

Step-by-step guide for performing engine oil and filter changes for proper lubrication.

Corrosion Protection Measures

Storage and Winterization

Preparing Power Package for Storage

Draining the Seawater System

Engine and Fuel System Preparation

Power Package Recommissioning

Troubleshooting Common Issues

Starter Motor Issues

Engine Starting Problems

Excessive Engine Temperature