Mercury 565 User Manual

5. Remove the tube from the oil fill/drain hole. Quickly install the sealing
washer and the oil fill/drain screw. Securely tighten the screw.
6. Add SAE 85W90 Mercury Racing Gear Oil to the monitor bottle.
7. When the oil starts to run out the the oil vent hole, reinstall the drive oil
vent screw and seal. Securely tighten the screw.
a - Gear lube monitor bottle
Tube Ref
No.
Description Where Used Part No.
SAE 85W90
Mercury Racing
Gear Oil
Gear lube monitor bottle 8M0078015
8. Continue adding gear lube until the oil level is at the top line marked
"OPERATING RANGE" on the bottle.
9. Lubricate the O‑ring on the neck with SAE 85W90 Mercury Racing Gear
Oil to ensure ease of installation and removal of the cap.
Tube Ref
No.
Description Where Used Part No.
SAE 85W90
Mercury Racing
Gear Oil
Monitor bottle cap 8M0078015
10. Install the filler cap, being careful to not overtighten.
IMPORTANT: Check the reservoir bottle oil level after the first use.
7333
a
MAINTENANCE
60 eng

Mercury 565 Specifications

General

Brand	Mercury
Model	565
Category	Engine
Language	English