1. Idle Speeds
Maintains the existing trim position.
2. Acceleration (hole shot)
Tucks the engine under to minimize
bow rise and improve time-to-plane.
Resume functionality
If the boat operator overrides Active Trim system at planing
speeds using the trim button or exceeds 50 mph (80 kph), the
system will stop controlling. Active Trim will resume automatically
under the following conditions:
• Override occurred above 50 mph (80 kph) and the boat operator
then decelerates below 50 mph (80 kph).
• Override occurred above 80% of rated engine RPM and the boat
operator then decelerates below 80% of rated engine RPM.
• Override occurred in cruising speed range and then the boat
operator decelerates to idle. Active Trim will become active on the
next acceleration.
Shallow water operation
Active Trim cannot detect water depth and will not trim up
automatically in shallow water. The boat operator will need to
override Active Trim by trimming the engine manually or pressing
the OFF button.
• If the boat operator trims above 50% trim position, the system will
remain in the standby / manual state and will not trim the engine
down automatically.
• Automatic control can be resumed by pressing On/Resume button.
Built-in GPS
This device includes a built-in GPS antenna used to determine
vessel speed. The GPS has three start-up modes:
• COLD START – If vessel battery power was turned off (using battery
switch), GPS will take between 30-60 seconds to acquire a signal.
• WARM START - If vessel battery power has been maintained
since last shutdown, GPS will acquire a signal in approximately 30
seconds.
• HOT START - If vessel has been keyed off for less than eight hours,
the GPS will acquire a signal in less than 10 seconds.
Active Trim system will not automatically control trim until GPS
has acquired a signal.
System Status LED flashing red light may indicate no GPS signal
has been acquired.
The Active Trim system has four modes of operation.
At boat startup, Active Trim resumes on/off state from the
previous shut down. For example, if Active Trim was on at
previous shut down, it will be on at next start-up.
3. Planing Speeds
Progressively trims the engine based
on GPS speed to maintain the most
efficient running attitude.
4. Override
When the boat operator uses manual
trim, the Active Trim system is
immediately overridden, returning
full control to the operator.
How it works What you need to know
Refer to your owner’s manual for
more detailed instructions.
To Previous Page
Need help?
General
