EasyManuals Logo

Mercury D4.2L User Manual

Mercury D4.2L
128 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
116
Excessive Engine Temperature
Possible Cause Remedy
Seacock closed, if so equipped Open.
Drive belt loose or in poor condition Replace and/or adjust belt.
Seawater pickups obstructed Remove obstruction.
Faulty thermostat Replace.
Coolant level low in closed cooling
section
Check for cause of low coolant level and repair.
Fill system with proper coolant solution.
Heat exchanger cores plugged with
foreign material
Clean seawater side of water/water
heat exchanger, and seawater strainer.
Loss of pressure in closed cooling
section
Check for leaks. Clean, inspect and test pres-
sure cap.
Closed cooling section dirty Clean and flush.
Faulty seawater pickup pump Repair.
Seawater discharge restricted or plugged Clean exhaust elbow.
Seawater inlet hose kinked (restricted) Position hose to prevent kinking (restriction).
Use of improperly designed hose on inlet side
of seawater pump allowing it to collapse
Replace hose with wire reinforced design.
Insufficient Engine Temperature
Possible Cause Remedy
Faulty thermostats Replace.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury D4.2L and is the answer not in the manual?

Mercury D4.2L Specifications

General IconGeneral
BrandMercury
ModelD4.2L
CategoryEngine
LanguageEnglish

Related product manuals