3.
Set the lanyard stop switch to RUN position. Refer to General
Information—Lanyard Stop Switch.
4. Set the tiller handle gear shift to the neutral start position.
5.
Cold engine ‑
•
Pull the choke knob out two detent positions for starting a cold engine.
The choke is closed in this position.
• After the engine is running, push the choke knob in one detent. The
choke is partially open in this position.
• After the engine starts to warm up, push the choke knob in. The choke
is open in this position.
a - Choke is open
b - Choke is partially open
c - Choke is closed
IMPORTANT: Outboards with battery charging capabilities must not be
operated with battery cables disconnected from the battery. Damage to the
charging system may result.
OPERATION
48 eng
To Next Page
Loading...
