MAINTENANCE
22
An anode is located on the water intake housing. An anode
requires periodic inspection, especially in salt water which will
accelerate the erosion. To maintain this corrosion protection,
always replace the anode before it is completely eroded. Never
paint or apply a protective coating on the anode as this will reduce
effectiveness of the anode.
a - Water intake housing anode
Lubricating the Driveshaft Bearing
Lubricate the driveshaft bearing before each use.
Tube Ref No. Description Where Used Part No.
95
2-4-C with Teflon Driveshaft bearing 92-802859A 1
IMPORTANT: It is important not to use a general all purpose
grease for this bearing. The lubricant recommended is a water
resistant grease of the proper consistency for this application. If a
substitute is used, be sure that it is water resistant and of the same
consistency.
1. Pull the vent hose off of the grease fitting.
2. Pump in grease through the grease fitting, using the grease
gun provided, until excess grease starts to exit the vent hose.
To Next Page
Loading...
Need help?
General