11
Jumper Settings
Using a jumper cap to connect two pins is SHORT, removing it
from these pins, OPEN.
CLEAR_CMOS1: Clear CMOS Jumper
Use this jumper to clear the contents of the CMOS memory. You
may need to clear the CMOS memory if the settings in the Setup
Utility are incorrect and prevent your motherboard from operating.
To clear the CMOS memory, disconnect all the power cables from
the motherboard and then move the jumper cap into the CLEAR
setting for a few seconds.
Function Jumper Setting
Clear CMOS Short Pins 2-3
Normal Short Pins 1-2
CLEAR_CMOS1
1
JP3
1
To Next Page
Loading...
Need help?
General
