16
Motherboard User’s Guide
Pin Signal
1CD IN L
2GND
3GND
4CD IN R
Here is a list of CD1 pin assignments.
Expansion Slots
This motherboard has one AGP, one CNR and two 32-bit PCI slots.
Follow the steps below to install an AGP/CNR/PCI expansion card.
1. Locate the AGP, CNR or PCI slots on the mainboard.
2. Remove the blanking plate of the slot from the system chassis.
3. Install the edge connector of the expansion card into the slot. Ensure the
edge connector is correctly seated in the slot.
AGP1
PCI1
PCI2
CNR1
To Next Page
Loading...
