Mercury MerCruiser 8.1S - Page 42

GASOLINE ENGINE 8.1 S INBOARD MODELS
Page 42 of 58
12. If proper positioning is still not obtained, remote control does not provide sufficient shift
cable travel and must be replaced.
73587
a
b
Typical ZF / Hurth Transmission Shown
a-Shift Lever
b-Shift Cable Bracket
13. Install nut and washer to cable end guide stud. Tighten until they contact, then loosen
1/2 turn.
14. Install nut and washer to cable barrel stud. Tighten securely, but DO NOT overtighten.
71780
71972
b
g
f
e
e
c
b
a
c
d
Typical Single Cable Installation - Rear Approach
a-Cable End Guide
b-Spacer (As Required)
c-Elastic Stop Nut And Washer
d-Bushings
e-Cable Barrel Location
f-Cable Barrel Stud
g-Cable End Guide Stud