GASOLINE ENGINE 8.1 S INBOARD MODELS
Page 45 of 58
11. If transmission shift lever is still not positioned properly for both gears, move anchor stud
on shift cable bracket to another hole and recheck shift cable position.
12. If proper positioning is still not obtained, remote control does not provide sufficient shift
cable travel and must be replaced.
13. Reattach nut and washer to cable end guide stud. Tighten until they contact, then loosen
1/2 turn.
14. Reattach nut and washer to cable barrel stud. Tighten securely, but DO NOT
overtighten.
50947
a
b
c
d
e
f
g
Rear Entry Single Station Installation In-Line And V-Drive
50947
a
b
c
d
e
f
g
Rear Entry Dual Station Installation In-Line And V-Drive
a-Cable End Guide
b-Cable Barrel
c-Cable Barrel Stud
d-Elastic Stop Nut And Washer
e-Spacer
f-Cable End Guide Stud
g-Elastic Stop Nut And Washer
To Next Page
Loading...
Need help?
General