Mercury SCC-1 - Wi-Fi Network Connection

10. Select the Wi‑Fi network that will be used for communication connection.
NOTE:Networks that do not require a password are acceptable to use. Captive portal Wi‑Fi networks, which require a
user to interact with a web page, cannot be used to configure this module.
NOTE:The device name uses the last 3 digits of the module serial number for identification.
NOTE:Wi‑Fi signal strength needs to be two bars to function properly.
72607
XXXXXXXXXX
11.
Enter the password needed for establishing a connection to a Wi‑Fi network. Select Connect.
72608
12.
After this data is entered, go to the Mercury Dealer or OEM Configuration Process: Step 11, to continue the
configuration process instructions.
SCC-1 SMARTCRAFT CONNECT GATEWAY INSTALLATION MANUAL
90-8M0219240 eng MAY2023 © 2023 Mercury Marine Page9 / 23