Why is there excessive noise and vibration from the driveline in my Meritor Industrial Equipment?
Excessive driveline angles are often the cause of driveline vibration and noise in Meritor Industrial Equipment. Ensure driveline angles do not exceed 5º, and the difference between any angles is not greater than 1.5º. Road test the vehicle to check if the noise or vibration persists.
What to do if the PTO does not engage or disengage correctly on Meritor Industrial Equipment?
If the PTO on your Meritor Industrial Equipment isn't engaging or disengaging correctly, start by checking the air connection to the PTO shift port and verifying the PTO engages and disengages correctly. Also, ensure the PTO has at least 60 psi (4.14 bar) of air pressure to operate correctly. Road test the vehicle to confirm the problem is corrected and return the vehicle to service.
Why is the seal leaking in the transfer case of my Meritor Industrial Equipment?
If a seal is leaking in the transfer case of your Meritor Industrial Equipment, it could be due to too much oil or the wrong type of oil, causing overheating and seal damage. Check the oil level and adjust if needed. After a road test, check for leaks before returning the vehicle to service.
What to do if the declutch does not engage or disengage correctly on Meritor Industrial Equipment?
If the declutch in your Meritor Industrial Equipment isn't engaging or disengaging correctly, turn the wheels left and right several times and try shifting the declutch again. Ensure the declutch has at least 60 psi (4.14 bar) of air pressure to operate correctly, and verify the transfer case shifts correctly. Road test the vehicle to confirm the problem is corrected.
How to fix a damaged transfer case or joint seal leaks in Meritor Industrial Equipment?
To address damaged transfer cases or joint seal leaks in Meritor Industrial Equipment, begin by cleaning the transfer case and operating the vehicle to inspect for housing damage and joint seal leaks. Check the transfer case for leaks. If needed, remove the transfer case, disassemble it, inspect the parts for damage, replace them as necessary, and then reassemble the transfer case. If the breather is clogged, replace it.
What to do if there is a gear shifting issue (high/low) in Meritor Industrial Equipment?
If you're experiencing gear shifting issues (high/low) with your Meritor Industrial Equipment, and the vehicle is stationary, shift the transfer case to neutral. Next, shift the transmission into 1st gear and lightly press the accelerator. Road test the vehicle.
General| Category | Industrial Equipment |
|---|---|
| Series | MTC-4213X |
| Type | Transfer Case |
| Brake Type | Integral |
| Hub Pilot | Yes |
| Wheel End | Single Reduction |
| Spindle Type | Straight |
| Bearing Type | Tapered Roller |
| ABS Compatible | Yes |
To Next Page
