Merrychef Mealstream 401 User Manual

12
Each program can comprise up to three stages, allowing at each
independent control of Convection temperature, Stage time and Microwave
power level. However, programs must be used with caution since if the
food to cook varies in weight or density then good results and more
importantly adequately cooked food may not be achieved. Therefore, it is
vital that all food prepared for service should be checked to ensure that
core temperatures have been achieved.
PressandholdPROGRAMPADuntilaashing‘P’
appears in the PROGRAM DISPLAY
Lights on the TEMPERATURE
SETTINGPADSashtoindi
-
cate that a temperature must be
selected.
Press the pad for the required
temperature, the light on the se-
lectedpadwillcontinuetoash,
the others will go out.
Enter required cooking time by
pressing the TIME SET PADS
(Thedisplaycolonsashtoindi-
cate a time is required).
1
2
3
Only valid times of Minutes and Sec-
onds will be accepted.
e.g. 1 minute 1 second not 61 secs
To cook the food using a combina-
tion of convected heat and micro-
wave press one of the POWER PADS
100%,75%,50% or 25%.
To cook using convection only press the
button marked with the fan symbol.
Check program details on the
ashingdisplay.Settingscanbe
changed by stepping back through
the program using the CANCEL
BUTTON.
To save as a single stage program
The program details
are displayed
momentarily as the
program is saved.
4
Press the required number pad
• Enter a valid time up to 30
minutes e.g.
1 minute 1 second not 61
seconds.
• Information
may be
programmed into the memory
whether the oven is hot or
cold.
• To review a program use
CALLBACK see page 13.
We recommend you keep a
note of program instructions
for future reference.
An amount of experimentation
will be required to determine the
correct program for a particular
product.
Pre-programming allows repetitive cooking procedures to be stored for ease
of use in up to 10 programs ( on menukey models up to 100 programs).
example: stage 1 saved as Program 8
example: stage 1, stage 2, stage 3
saved as Program 8, 08
To save as a multi-stage program
PROGRAMMING NUMBER PADS
Follow steps 1– 4 for each stage
of cooking and on completing
press the PROGRAM PAD to
enter a second and third stage of
cooking to the program.
Press the required number pad to
save the program.
MENUKEY
Note: some MENUKEY settings
will prohibit the programming of
individual number pads
Menukeymodelsshowaashing
‘PP’ in the display
non-Menukey
models
Menukey
models
Menukey
models
MENUKEY models
These store up to 100 programs
and need to be stored and
accessed by 2 buttons 00-99

Merrychef Mealstream 401 Specifications

General

Brand	Merrychef
Model	Mealstream 401
Category	Microwave Oven
Language	English