Need help?Do you have a question about the Mesa/Boogie ELECTRA DYNE and is the answer not in the manual?
General| Power Output | 90 Watts |
|---|---|
| Footswitchable Channels | Yes |
| FX Loop | Yes, Series FX Loop |
| Type | Tube Amplifier |
| Channels | 2 Channels |
| Tubes | 12AX7 |
| Reverb | Yes, Spring Reverb |
| Controls | Gain, Master, Treble, Mid, Bass, Presence, Reverb |
| Speaker Outputs | 8 Ohm |
| Footswitchable | Channel Switching |
Essential operating guidelines and warnings for safe amplifier use.
Critical notice regarding permanent hearing damage risk from high volume levels.
Introduction to the Electra Dyne's three modes and overall design philosophy.
Detailed explanation of the CLEAN channel's sound characteristics and controls.
Detailed explanation of the VINTAGE LO channel's sound characteristics and controls.
Detailed explanation of the VINTAGE HI channel's sound characteristics and controls.
Explanation of MID and BASS controls and their impact on tone.
Explanation of PRESENCE and MASTER controls and their functions.
Operation of STANDBY and POWER switches for amp setup and wattage.
How to select between 6L6 and EL34 power tubes for different tones.
Information on fuses, their function, and replacement procedures.
Details on the Effects Loop and Reverb control and their usage.
Connection and usage of speaker outputs and slave level control.
Controls for fine-tuning gain and clean channel volume.
Guide to identifying and resolving power and pre-amp tube issues.
Instructions for matching speaker impedance and wiring configurations.
Step-by-step instructions for replacing tubes in the amplifier.
Explains triodes, pentodes, and electron flow principles in tubes.
Visual layout of controls and components for the Head version.
Visual layout of controls and components for the Combo version.
To Next Page