Need help?Do you have a question about the Mesa/Boogie Lonestar Special and is the answer not in the manual?
General| Type | Tube Amplifier |
|---|---|
| Channels | 2 |
| Preamp Tubes | 5 x 12AX7 |
| Power Amp Tubes | 4 x EL84 |
| Speaker | 1 x 12" Celestion Custom 90 |
| Effects Loop | Yes |
| Reverb | All-Tube, Long Spring |
| Controls | Gain, Treble, Mid, Bass, Presence, Reverb, Master |
| Speaker Outputs | 1 x 4 Ohm |
| Wattage | 5, 15, or 30 Watts (Switchable) |
| Footswitch | Included (Channel Switching, Solo, Reverb) |
The primary input jack for connecting your instrument to the amplifier.
Connection for the footswitch to remotely control channels and features.
Pre-drive control for Channel 2, affecting preamp gain and saturation.
Manual toggle for selecting between Channel 1 and Channel 2.
Switch to activate/deactivate Channel 2's overdrive circuitry for different gain levels.
Voicing switch that affects treble frequency response and gain.
Adjusts the predominant gain stage for each channel's circuit.
Primary tone control affecting treble frequencies, influencing mid and bass.
Guides on identifying and resolving issues with power tubes.
To Next Page