Mesa MH101 - CHANGING THE OVERRIDE; Changing The Override Code; Changing The Override Card; CHANGING THE BATTERIES

3. Inertthe emergencykeyandturnclockwise a quarterturn(donotforce the keyintothe lock).
4. Toremove the keyyoumustturnthe keycounterclockwise,a quarterturn,backtothe inserted
position.
ñ Emergencykeyswillnotplace the safe intothe unlockedstate.
ñ Toplace the safe intothe unlockedstate youwillneedtouse the override code orcard.
ñ DO NOT STORE THE EMERGENCY KEYSIN THE SAFE.
CHANGING THE OVERRIDE
ChangingTheOverrideCode
1. Safe mustbe inthe unlockedposition.
2. Input—*“ +—*“,and—PROG“ appears.
3. Input—842627“+—#“,and—OLD“ appears.
4. Inputthe currentoverride code +—#“,and—NEW “ appears(Note:the defaultoverride code is
—000000“).
5. Inputa new six-figure override code +—#“,and—AGAIN“ appears.
6. Re-enterthe new override code +—#“,and—GOOD“ appears,whichmeansthe override code hasbeen
changed successfully.
ChangingTheOverrideCard
1. Safe mustbe inthe unlockedposition.
2. Input—*“ +—*“,and—PROG“ appears.
3. Input—726248“+—#“,and—CARD“ appears.
4. Now swipe the CardyouwantsetasyourOverride Card,and—GOOD“ appears,whichmeansthe
override cardhasbeensetsuccessfully.
W ARNINGS
ñ W hen—LO-BATT“ appears,the safe isindicating thatthe batteriesare low anditistime tochange
them.
ñ W hen—E-BAR“ appears,the safe isindicating thatthe doorisnotclosedproperlyorthere couldbe
something preventing the boltsfrom locking.
ñ Press—#“ whenthe safe isinthe lockedpositionand—BATT-H“ willappearifthe batterylevelishigh
or—BATT-L“ willappearifthe batterylevelislow.
CHANGING THE BATTERIES
1. Unlockthe safe,ifthe batteriesare deadinthe lockedpositionyouwillneedtouse the emergencykey.
2. The batterycompartmentislocatedinside the safe onthe door.
3. Remove the fourAA batteriesandreplace withnew ones.
CHANGING THE LOCK SET-
TINGS
1. Safe mustbe inthe unlockedposition.
Slot1 Slot2 Slot3 Slot4 Slot5 Slot6
2. Input—*“ +—*“,and—PROG“ appears.
3. Input—711469“ +—#“,and—CODE“ appearsfollowedbya six-digitnumber.
4. The firstsix-digitnumber(defaultsettingis—111121“)isnow displayedandslot#1 isblinking .
ñ Toadvancetothenextslotwithoutmakingchangestothecurrentslot,enterthenumber
displayedinthecurrentslot.
ñ Press—#“ifyoudonotwanttomakeanychangestothefirstsix-digitnumberandmoveonto
thesecondsix-digitnumber. 
ñ Press—*“ifyouwanttostartoverandgobacktoslot#1. 
Page 3
http://www.monomachines.com/
http://www.monomachines.com/