Why does the apron not operate on my MetalMaster PB-860T Industrial Equipment?
If the apron on your MetalMaster Industrial Equipment isn't operating, it could be due to low pressure or leakage in the lifting cylinders. Check the system pressure. If there's a leak, replace the piston seal. Also, pressing the reset button might solve the problem.
How to fix uneven material bend on MetalMaster PB-860T Industrial Equipment?
If the material bend is uneven on your MetalMaster Industrial Equipment, it could be due to several reasons. The clamp setting might be wrong for the material thickness, so you should re-adjust the cam settings. Also, the finger edges might be uneven, in which case you should adjust the pan clearance and the fingers.
General| Model | PB-860T |
|---|---|
| Category | Industrial Equipment |
| Type | Plasma Cutting Machine |
| Working Gas | Compressed Air |
| Control System | CNC |
| Motor Power | 1.5 kW |
| Cutting Thickness | 0.5-25mm |
| Air Pressure | 0.4 - 0.8 MPa |
Detailed technical specifications for different Metalmaster Panbrake models, including dimensions and capacities.
Essential safety guidelines and precautions for operating the machinery safely.
Procedure for adjusting the clamp gap based on material thickness.
Common problems and their solutions for machine operation.
Guide to operating the machine using the NC-89 digital controller.
Instructions for using the machine's touch screen interface for bending operations.
Broad safety guidelines applicable to all machinery use.
Specific safety warnings and procedures for operating hydraulic panbrakes.
To Next Page
