METER AROYA H210 - Operating the AROYA System; Installation and Setup

2. OPERATION
Please read all instructions before operating the AROYA to ensure it performs to its
fullpotential.
PRECAUTIONS
METER sensors are built to the highest standards, but misuse, improper protection, or
improper installation may damage the sensor and possibly void the manufacturer’s
warranty. Before integrating AROYA into a system, make sure to follow the recommended
installation instructions and have the proper protections in place to safeguard sensors
from damage.
2.1 INSTALLATION
Follow the steps listed in Table1 to set up the Gateway.
Table1 H210 Gateway Installation
Tools Needed Cordless drill
Screw driver
Screws
Preparation Consider the Surroundings
Locate the Gateway in a hallway or office with internet access for PoE.
The site network infrastructure will determine what installation method is
required so the Gateway can communicate with other parts of the system.
If this is not possible, locate the Gateway wherever there is access to
connections required to establish communication.
The Gateway needs to be close enough to the Repeater(s) for the signal from
the Repeater to reach the Gateway.
Verify Internet Connectivity
Log into the AROYA software or mobile app.
Go to the Devices pages.
Select Gateway under All Devices.
A check mark icon indicates the Gateway is connected to the internet.
Mounting METER recommends putting the Gateway on a table or shelf.
Configuration
All system configuration work is done at METER before installation occurs at
the customer site.
3
AROYA