Metra Electronics 95-3005 User Manual

Metra. The World’s Best Kits.
®
MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 12/4/18 INST95-3005
INSTALLATION INSTRUCTIONS
95-3005
Attention! Let the vehicle sit with the key
out of the ignition for a few minutes before
removing the factory radio. When testing the
aftermarket equipment, ensure that all factory
equipment is connected before cycling the
key to ignition.
KIT FEATURES
• ISO DDIN radio provision
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets • C) Cutting template
A B C
Chevrolet Astro/GMC Safari 1995-2005
Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle
specific applications
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• Cutting tool • Scribe tool
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Preparation .......................................................2
Kit Assembly ..........................................................3
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: 70-1858
Antenna Adapter: 40-GM10
Pocket: 88-00-3302

Metra Electronics 95-3005 Specifications

General

Brand	Metra Electronics
Model	95-3005
Category	TV Mount
Language	English

Summary

Dash Disassembly

Parking Brake and Gear Selector

Engage the parking brake and place the gear selector in the lowest position before starting disassembly.

Dashboard Trim Panel Removal

Unclip, unplug, and remove the dashboard trim panel to access the radio.

Factory Radio Removal

Depress tabs securing the radio, slide it out, unplug, and remove.

Kit Preparation

Cut Template Placement

Place the cut template over the dashboard trim panel for marking.

Scoring and Cutting

Use a scribe tool to score the radio section, then cut the marked area.

Trim Panel Attachment

Clip the prepared radio trim panel onto the dashboard trim panel.

Kit Assembly

Secure Radio Brackets

Attach the radio brackets to the new radio using the supplied screws.

Wiring and Antenna Connections

Connect the factory wiring harness and antenna connector to the new radio.

Radio Assembly Installation

Clip the assembled radio unit into the dashboard.

Final Dash Reassembly

Reassemble the dashboard in reverse order to complete the installation.

Troubleshooting and Support

Technical Support Contact

Contact Tech Support via phone or email for installation difficulties.

Instruction Review

Review the instruction booklet again before contacting support.

Installer Training Recommendation

Metra recommends MECP certified technicians and Installer Institute training.