Metrix MX2034 User Manual

Doc# 100576 • REV C (Sept 2017) Page 15 of 42

3.5.4.1 PROBE SERIES
All DPS units support Metrix MX2030, Metrix 10,000 series 7200 compable, Bently Nevada
3300, and Bently Nevada 7200 series probes. The DPS also supports one addional probe
type specied at the me of ordering.
3.5.4.2 PROBE DIAMETER
The DPS supports 5mm, 8mm and 11mm probe p diameters as part of its standard factory-
loaded curve set.
3.5.4.3 TARGET MATERIAL
DPS units support the standard four probe series listed in secon 3.5.4.1 calibrated for 4140
steel. The addional probe type specied at the me of ordering may be calibrated to a
variety of materials. Contact Metrix for informaon on special material calibraons.
3.5.4.4 MEASUREMENT
The Measurement eld is only acve for the MX2034 transmier model. The MX2034 sup-
ports three measurements: Radial Vibraon, Axial Posion, and Sha Speed (RPM).
3.5.4.4.1 RADIAL VIBRATION
The MX2034 performs a peak to peak detecon and drives the 4-20 mA output proporonal
to the congured range.
1) Select the new conguraon
parameters from the drop down list
2) Click the  buon to send the new
conguraon to the DPS

Metrix MX2034 Specifications

General

Brand	Metrix
Model	MX2034
Category	Measuring Instruments
Language	English