9
V. MAINTENANCE
A. CABINET MAINTENANCE —
ALL MODELS
Your C175 series cabinet has been
designed to require very little maintenance.
With normal use, cleaning is the only form of
maintenance that need be done on a regular
basis. Keeping the casters free of dirt build-
up will go a long way in prolonging their life.
If your cabinet is rolled over rough surfaces
or transported over-the-road, the various
threaded fasteners, i.e., screws and nuts,
should be periodically inspected and
tightened if necessary, particularly the
transport latch, hinge and caster fasteners.
B. MODULE MAINTENANCE
The module in the base of your cabinet has
also been designed to require very little
maintenance. With normal use, cleaning is
the only form of maintenance that need be
done on a regular basis. When cleaning, do
not spray or pour water on the module and
do not immerse the module in water. Wipe
with a damp cloth and dry with a towel.
Keeping vital areas such as the air-inlet area
and the controls area free of dirt build-up will
go a long way in prolonging the life of the
electrical components. No maintenance is
required on the electrical components.
C. BLOWER MOTOR MAINTENANCE
The blower motor bearings should be
lubricated annually.
1. To gain access to the motor, follow the
instructions listed on page 12.
2. Remove the (2) rubber plugs, (1) located
at each end of motor.
3. Apply 6 drops of a SAE 20 non-detergent
oil to each bearing and re-install plugs.
4. Re-assemble module.
To Next Page
Loading...
Need help?
General
