GB
- 16 -
4. When the “vacuum” and sealing process is
finished, open the vacuum lid (1) and inspect the
seal. If necessary, adjust sealing time and seal
again. If the seal is satisfactory, you can use the
vacuum pouch like a regular one.
5. After use
• Clean the appliance and accessories after each
use.
• Unplug before cleaning.
• Do not use chemical, alkaline, abrasive or other
aggressive detergents as they might be harmful
to the surfaces.
• Clean the appliance with a soft damp cloth and
a mild detergent to remove crumbs, dust, liquids,
etc.
• Let the appliance dry thoroughly before storing.
• Store the appliance in a dry environment at room
temperature.
• Keep the appliance out of reach of children.
6. Troubleshooting
Problem Possible cause Solution
The LED
display (12)
shows error
code “E01”.
Vacuum lid (1)
is not properly
closed.
Close vacuum lid (1).
If error code continues
to show, it is an
electronics problem.
In this case, please
consult customer
service or a qualified
technician.
Appliance does
not turn on.
Appliance is not
properly plugged
into a grounded
outlet.
Plug appliance into a
grounded outlet. Make
sure to plug it in tightly.
Power cord is
damaged.
Check the power cord
for tears and frays. If
damage is confirmed,
do not use the
appliance and consult
a qualified technician.
ON/OFF button
(7) was not
properly pressed.
Press ON/OFF button
(7).
Problem Possible cause Solution
Appliance
does not pull
a complete
vacuum.
Vacuum/sealing
time is not set
high enough.
Set vacuum and
sealing times higher
and vacuum again.
Pouch is not
placed correctly
across seal bar
(3) and/or within
vacuum chamber
(2).
Reposition the pouch.
Make sure the open
end of the pouch is
across the seal bar (3)
and inside the vacuum
chamber (2) and there
are no wrinkles in the
pouch along the seal
bar (3). If sealing is
incorrect, cut off the
seal and make a new
one.
If packaging from
a roll pouch,
first seal may be
incomplete or
there are gaps in
one of the seals.
Make sure first seal is
complete and there are
no gaps or wrinkles in
either seal. If sealing
is incorrect, cut off the
seal and make a new
one.
Appliance and
vacuum pouch
are not clean and
dry.
Wipe the surface of the
seal bar (3) and the
upper inside part of the
pouch and try again.
Vacuum pouch
loses vacuum
after being
sealed.
Seal is not
correct.
Leaks along the seal
may be caused by
creases, crumbs,
grease or liquids.
Reopen the pouch and
clean its upper inside
part before resealing.
Sharp edges of
items in vacuum
pouch punctured
small holes into
pouch.
Cover sharp edges
with paper towel and
vacuum in a new
pouch.
Fruits and
vegetables which
release gases
if not properly
blanched or
frozen before
packaging were
put into vacuum
pouch.
Open pouch. If you
think spoilage has
begun, discard food. If
food spoilage has not
yet begun, consume
immediately. If in doubt,
discard food.
To Next Page
Loading...
Need help?
General