Metso HP5 - Page 46

© Metso
)+
Note:
The T1 and 1 seals o" the
counterweight o" the
curr
ent
design are an integral part o" the
counterweight 3 they
ar
e
machined into the counterweight.
Older counterweights had plastic
T1 and 1 seals that were
glued into position much the
same as the 1 seal that4
s glued
into the main "rame or the T1
seal that4
s glued into the head.
%#& 'eal
%T& 'eal
Eccentric assembly
3ounter6weig
ht K7
and KT
seals