Need help?Do you have a question about the Metso Lokotrack ST4.8 and is the answer not in the manual?
General| Brand | Metso |
|---|---|
| Model | Lokotrack ST4.8 |
| Category | Industrial Equipment |
| Language | English |
Essential safety guidelines and hazards to be aware of before and during machine operation.
Visual indicators and instructions for navigating the machine's movement path.
Identifies the physical locations of all emergency stop buttons on the machine.
Specifies the location of the remote stop button for emergency shutdown.
Details the different methods and devices used to control the machine's movement.
Instructions for operating the wired control device for machine movement.
Guidance on using the optional wireless remote control for machine operations.
Steps to ensure the machine is ready and safe for transportation or movement.
Procedure to adjust machine configuration for safe movement on inclines.
Step-by-step guide to safely start the machine's engine.
Instructions for connecting either the wired or wireless control units to the machine.
Procedure to connect the physical drive control device to the machine's socket.
Steps to establish a connection with the optional wireless radio control unit.
Guidance on how to operate the machine's track drive system.
Instructions for maneuvering the machine using the drive control device.
Instructions for maneuvering the machine using the radio control device.
Procedure for correctly shutting down the machine's engine.
Solutions for problems encountered during machine operation and startup.
Resolving issues where the machine's control panel display fails to power on.
Identifying and rectifying reasons why the engine fails to start.
Troubleshooting steps for when the wireless control device is unresponsive.
Diagnosing and fixing problems with the machine's track movement system.
Addressing problems like rough running or sudden engine stoppage.
Guidance on understanding and responding to system error messages.
Resolving the specific 'A17: Remote stop active' warning message.
Actions to take when an emergency stop alarm is active on the display.
Procedures for fixing common operational problems and performing checks.
Procedure to verify and set the main power switch to the ON position.
Verifying that no emergency stop buttons are currently engaged.
Ensuring the remote stop button is not pressed, to enable operation.
Confirming that manual valves are in the OFF position for track driving.
Ensuring the battery terminals are properly connected and secured.
Instructions for charging the 24 VDC battery of the Lokotrack unit.
Procedure for charging the battery of the optional radio control device.
Method for starting the engine using another vehicle and jumper cables.
Instructions for using a portable jump starter to start the engine.
How to monitor and refill the machine's fuel level.
Understanding and responding to various alarm and warning messages.
Specific steps to clear the 'A17: Remote stop active' alert.
Procedure to reset the machine after an emergency stop activation.
Adjusting machine angle for safe driving on slopes.
Procedure to inspect hydraulic oil levels and check for fluid leaks.
Instructions for opening the hydraulic main valve to allow operation.
Steps to cool down the hydraulic oil if it exceeds operating limits.
Checking if manual controls are active and disabling them for track driving.
How to stop the screening process to enable track driving.
To Next Page
