Metso Lokotrack ST4.8 User Manual

Cause
Manual controls are active.
Remedy
The machine cannot be driven to any direction.
1. Check if manual controls are active. See Checking if manual controls are active .
Cause
Drive control device or radio control device was connected before starting the engine.
Remedy
The machine cannot be driven to any direction.
1. Reconnect/Reactivate the control device.
1.11.5 Engine is not running properly or it suddenly stopped
Cause
Fuel tank is empty.
Remedy
The machine cannot be driven.
1. See Checking the fuel level .
Cause
When driving on a sloping surface or onto a trailer truck, the automation system may stop the machine if the
hydraulic fluid or the coolant level is too low.
Remedy
The machine cannot be driven.
1. See Correcting too large inclination angle of the machine .
1.11.6 System display shows an alarm
Cause
Engine did not start.
Remedy
Engine start is prevented.
1. See Handling alarms .
1.11.7 System display shows an ‘A17: Remote stop active’ alarm
Cause
Remote stop button is pressed down.
Remedy
Engine start is prevented.
1. See Handling the 'A17: Remote stop active' alarm .
Lokotrack ST4.8 / ST4.10
Driving Instructions
Copyright
©
Metso 2023. All rights reserved. 33 (46)
Project ID: Plant Code: Plant Unit Code: Document Type: Running No: Revision:
0
Metso Document ID:
D100014616

Metso Lokotrack ST4.8 Specifications

General

Brand	Metso
Model	Lokotrack ST4.8
Category	Industrial Equipment
Language	English