Metso Lokotrack ST4.8 User Manual

NOTE: Make sure that the plug covers in the Lokotrack are closed.
NOTE: For security reasons, only one drive control device is allowed to be used with the Lokotrack.
If the original drive control device is replaced with a spare part control device, the original must be
destroyed.
NOTE: The cable drive control device cannot be used with the radio control mode (optional)
switched on.
1.5.2 Radio control device (optional)
A
B
A
B
2
3
4
10
6
98
7
1
5
Figure 6. Radio control device
Callout Description Callout Description
1 Status of the radio
control device:
• OFF: no light
• ON: green light
• Transmitting ON:
green light blinking
• Low battery: red light
blinking
6
Radio control lever, left
track
A = forward, B =
backward
2
Grid lifting (UP)
(optional)
Grid lowering (DOWN)
(optional)
7
Remote stop (push and
pull button)
Crushing/screening,
hydraulic operations,
Lokotrack ST4.8 / ST4.10 Driving Instructions
Copyright
©
Metso 2023. All rights reserved. 11 (46)
Project ID: Plant Code: Plant Unit Code: Document Type: Running No: Revision:
0
Metso Document ID:
D100014616

Metso Lokotrack ST4.8 Specifications

General

Brand	Metso
Model	Lokotrack ST4.8
Category	Industrial Equipment
Language	English