Metso Lokotrack ST4.8 User Manual

1
2
Callout Description
1 Remote stop button in drive control device
2 Remote stop button in radio control device
Figure 4. Location of remote stop button
NOTE: To stop the engine with the remote stop button of the drive control device, the drive control
device must be connected.
NOTE: To stop the engine with the radio control remote stop, the function requires following:
• Radio control is selected on.
• Radio transmitter is on and in the operating range.
1.5 Drive controls
1.5.1 Drive control device
WARNING
UNEXPECTED MOVEMENT HAZARD
Can cause death or serious injury.
Make sure the cable of the drive control device does not get caught in the tracks or in any other
moving part of the machine during driving.
You must disconnect the drive control device from the unit immediately after driving and store it in a
safe place when not in use.
Only lift and hold the drive control device by its handles. Do not pull the drive control device from the
cable.
Lokotrack ST4.8 / ST4.10
Driving Instructions
Copyright
©
Metso 2023. All rights reserved. 9 (46)
Project ID: Plant Code: Plant Unit Code: Document Type: Running No: Revision:
0
Metso Document ID:
D100014616

Metso Lokotrack ST4.8 Specifications

General

Brand	Metso
Model	Lokotrack ST4.8
Category	Industrial Equipment
Language	English