Metso HP5 - Installation

© Metso
+5
5
7se the ? centering bolts -dia" <9mm/ 'rom the tool
kit& screw them in t
he threaded holes o' the socket"
5
*crew the ? eye bolts" >ently heat the bottom o' the
socket until the tem%erature is 193 above ambiant"
5
uickly slide down the socket on the sha't to%" Make
sure the socket is %ro%erly seated -check with 'eeler
gauges/"
5
0emove the centering bolts& and use the 'i$ation bolts
-dia 8Hmm& length 9mm& tor,ue <99 N"m/"
5
Once the socket has cooled down& check again the
tor,ue" Oil the socket s%herical sur'ace -#*O 338=9/"
*ocket assembly
#nstallation