32
APPENDIX A
CAUTION: Do not use a screw gun or similar
device to attach the retainer strip, as the
excess torque may crack or damage it.
4. Check the rain hood to assure that the gasket material
is firmly attached all along the inner edges, and that two
butterfly-type latch “keys” are inserted in each of the
two shorter sides of the hood.
5. Holding the rain hood at a slight angle away from the
enclosure, rotate the top (long) edge of the hood into
the slot formed by the retainer strip. Push the hood
upward into the slot until it stops.
6. Move the hood toward the enclosure until it makes
contact and its side edges are within the insets/
recesses on the left and right sides of the amplifier
chassis. Press in to compress the foam against the
enclosure.
7. Holding the rain hood in place, firmly push the latch
keys one at a time into their mating holes on the two
sides of the amplifier chassis, and once inserted
completely give a quarter-turn clockwise to lock.
8. To remove the rain hood, reverse steps 5 through 7.
To Next Page
Loading...
Need help?
General
