7
CHAPTER 1
NOTE: For best performance, the AC cable
voltage drop should not exceed 10 volts, or
10 percent at 115 volts and 5 percent at 230 volts.
Make sure that even with the AC voltage drop the
AC voltage always stays in the operating windows.
The minimum electrical service amperage required by
the M2D-Sub system is the sum of each loudspeaker’s
maximum continuous rms current. An additional 30 percent
above the minimum amperage is recommended to prevent
peak voltage drops at the service entry.
CAUTION: In the unlikely event that the
circuit breakers trip (the white center buttons
pop out), disconnect the AC power cable. Do not
reset the breakers with the AC connected. Contact
Meyer Sound for repair information.
CAUTION: The M2D and M2-Sub
loudspeakers require a ground connection.
Always use a grounded outlet and plug.
To Next Page
Loading...
