Meyer VANTAGE-VAC - Maintenance

8
ENGINE: The cooling fan screen should be cleared of dust and debris aer every use. Refer to the
engine manual provided for addional service and maintenance.
BATTERY: The baery provided with your equipment is of the lead acid type. The baery cables
should be checked daily for corrosion and ghtness.
FAN HOUSING AND WHEEL: During the normal use of your vacuum, no maintenance is required on the
fan wheel or housing.
If a problem noise or vibraon should occur, stop the equipment immediately!! Contact the factory as
soon as possible. Do not operate this equipment unl it has been thoroughly checked by the factory or
factory authorized representave.
The fan wheel assembly has been balanced at the factory. Noises or vibraons
coming from the fan indicate that for some reason the fan wheel has gone out
of balance. The fan assembly is rotang at nearly 3600 rpm and if the fan wheel is out of balance,
the possibility that the fan wheel will explode in the housing is high. The vacuum MUST be shut
down immediately. Failure to do so could lead to serious injury or death and costly damage to the
equipment.
The fan wheels are designed and manufactured specically for these vacuums. Replacement fan
wheels are only available from the manufacturer, do not aempt to substute. Contact Wm. W. Meyer
& Sons for replacement parts and if you have any quesons or concerns at 1-800-963-4458.
SECTION VI
MAINTENANCE