EasyManua.ls Logo

MFJ MFJ-815D User Manual

MFJ MFJ-815D
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
INSTRUCTION MANUAL
CAUTION: Read All Instructions Before Operating Equipment
MFJ ENTERPRISES, INC.
300 Industrial Park Road
Starkville, MS 39759 USA
Tel: 662-323-5869 Fax: 662-323-6551
COPYRIGHT 2013 MFJ ENTERPR ISES, INC.
C
VERSION 1A
D
Model MFJ-815D
1.8-60MHz
Question and Answer IconNeed help?

Do you have a question about the MFJ MFJ-815D and is the answer not in the manual?

MFJ MFJ-815D Specifications

General IconGeneral
BrandMFJ
ModelMFJ-815D
CategoryMeasuring Instruments
LanguageEnglish

Summary

Product Introduction

Product Overview

Details the MFJ-815D SWR/Wattmeter, its purpose, and key features like peak reading and a cross-needle meter.

Device Installation

Connecting Antenna and Transmitter

Connect transmitter to TRANSMITTER port and antenna to ANTENNA port using quality coax and connectors.

Power Supply Needs

Unit requires DC power (9 VDC battery or 12 VDC external) for operation; lamp needs 12 VDC.

Using a Dummy Load

Connect a 50-ohm dummy load to the ANTENNA connector to measure transmitter/amplifier power output.

Device Operation

Powering On and Range Selection

Push the ON/OFF button to turn the unit on. Select power ranges using the 3000/300 Watt button.

Understanding Peak vs. Average Power

PEAK/AVG button selects peak envelope power (PEP) or average power; PEP readings differ on SSB.

How to Read Power Scales

Forward and reflected power are read on the meter scales, with values dependent on selected Watt range.

Measuring SWR and True Power

SWR is read where needles cross. True power is derived by subtracting reflected from forward power.

Device Calibration

Calibration Equipment Requirements

Lists required equipment: transmitter, dummy load, accurate power meter, and suitable cables for calibration.

Calibrating Forward Power Scales

Adjusts HI FWD and LO FWD trim pots to set the 3000W and 300W forward power scale accuracy.

Calibration Refinements

Calibrating Reflected Power Scales

Adjusts HI REF and LO REF trim pots for 100W and 60W reflected power scale accuracy.

Note on SWR Calibration

States that SWR requires no calibration, as it is directly derived from forward and reflected power readings.

Technical Support

Contacting MFJ Technical Support

Provides contact information for MFJ Technical Service via phone, mail, FAX, and email for operational support.

Circuit Schematics

Sensor Board Circuit Diagram

Diagram showing the electronic components and connections for the sensor board of the SWR/Wattmeter.

Meter Board Details

Meter Board Circuit Diagram

Diagram illustrating the components and circuitry of the meter board, including amplification and meter drivers.

Product Warranty Information

Warranty Terms and Conditions

Details the warranty period, proof of purchase requirements, exclusions, and conditions for repairs or replacements.

Out-of-Warranty Service Procedure

Explains the procedure and associated charges for servicing units that fall outside the warranty period.

MFJ Service Contact Details

Provides the mailing address for sending MFJ products for in-warranty or out-of-warranty service.

Related product manuals