MFJ-815D Deluxe HF True Peak Reading SWR/Wattmeter Instruction Manual
4
Calibration
The MFJ-815D has been calibrated at the factory. If it should ever need to be
recalibrated, then follow this procedure:
Equipment Needed
1. Transmitter capable of supplying enough power to obtain ½ to full-scale reading
at 14 or 21 MHz.
2. 50-ohm dummy load that is capable of handling full transmitter output power and
has better than a 1.15:1 SWR.
3. Power meter of know accuracy. The calibration will only be as good as the
standard reference meter.
4. 50-ohm cables capable of handling the power. RG-58/u is recommended. DO
NOT USE RG-59 or RG-11.
Meter Calibration
1. Refer to Figure 1 for the Test Setup and refer to the PCB layout in Figure 2 for
trim pot location.
2. Remove the top of the MFJ-815D.
3. Connect the Test Setup equipment as shown in Figure 1. Use a 50-ohm dummy
load for the antenna. Set the Transmitter to the 14 MHz in the 20-meter band.
4. With the 3000/300 Watts button pushed out for the 300 Watt scale, Transmit 100
Watts as indicated on the reference meter. Adjust the LO FWD trim pot to set the
forward power scale to 100 Watts.
5. With the 3000/300 Watts button pushed in for the 3000 Watt scale, Transmit
1000 Watts as indicated on the reference meter. Adjust the HI FWD trim pot to
set the forward power scale to 1000 Watts.
6. To set the reflected power, interchange the TRANSMITTER and ANTENNA
coax cables so that the transmitter is connected to the ANTENNA connector and
the dummy load is connected to the TRANSMITTER connector.
7. With the 3000/300 Watts button pushed out for the 60 Watt reflected scale,
Transmit 10 Watts as indicated on the reference meter. Adjust the LO REF trim
pot to set the reflected power scale to 10 Watts.
To Next Page
Loading...
