Body
Fittings
Fitting the
Assemble the hood cover rail (IS) and fit it into the hood support sockets with
hood cover
the cross-rod towards the rear.
Fig.
76
and
77
Lay the hood cover over the rail and thread the two seat belt quick-release
fasteners
(16)
through the holes in the cover.
Engage the cover rear rail in the two anchor plates (17) on the tonneau panel.
Pull the cover slightly forwards and engage each side hook in its socket
(18)
on
the body panel.
Secure the fasteners
(19)
at each quarter side panel.
Secure the four fasteners
(20)
inside the car.
Removing the
Reverse the fitting procedure.
hood cover
Stowage
Stowage bags are provided to protect the hood cover and hood cover rail. The
stowage bags, together with the tool bag, are stowed in the luggage compartment
and secured with the straps provided.
Fig.
16
l
To Next Page
Loading...
