Why is my MGE UPS Systems UPS operating on battery even when AC power is available?
If AC power is available but your MGE UPS Systems UPS is operating on battery power, it could be because the circuit breaker located under the UPS has been tripped by an overload. Try disconnecting some equipment and reset the circuit breaker by pressing the button.
What to do if connected devices are not supplied when AC power fails for MGE UPS Systems UPS?
If your devices aren't getting power from the MGE UPS Systems UPS during an AC power failure, make sure they are connected to the battery backup outlets.
How to fix battery backup outlets not working on MGE UPS Systems Ellipse 600?
If the battery backup outlets on your MGE UPS Systems UPS aren't supplying power, press the button and check that it turns green.
What to do if the red LED is on and the audio alarm beeps every 30 seconds on my MGE UPS Systems Ellipse 600?
If the red LED is on and the audio alarm beeps every 30 seconds, it means the battery backup outlets on your MGE UPS Systems UPS are overloaded. To resolve this, disconnect some of the equipment connected to the battery backup outlets.
Why does the green button flash and the alarm beep on my MGE UPS Systems Ellipse 600?
If the green button on your MGE UPS Systems UPS flashes and the audio alarm beeps, it indicates that the UPS is frequently operating on battery power due to a poor AC power source. You should have your electrical installation checked by a professional or try using another wall outlet.
What to do if the filtered outlets are not supplied on my MGE UPS Systems UPS?
If the filtered outlets on your MGE UPS Systems UPS are not supplied with power, first ensure the wall outlet has power. If the wall outlet is working, the circuit breaker located under the UPS might have been tripped due to an overload. In that case, disconnect some equipment and reset the circuit breaker by pressing the button.
Why is the telephone line disturbed when using MGE UPS Systems UPS?
If the telephone line is disturbed or modem access is not possible when using your MGE UPS Systems UPS, it might be because surge protection on the telephone line is no longer provided. Disconnect the telephone line from the wall outlet.
What does it mean if the red LED is flashing on my MGE UPS Systems Ellipse 600?
If the red LED on your MGE UPS Systems UPS is flashing, it indicates that the battery has reached the end of its service life. You will need to have the battery replaced.
What does it mean when the green LED is off but the filtered outlets are supplied on MGE UPS Systems UPS?
If the green LED is off and the filtered outlets are still supplied on your MGE UPS Systems UPS, surge protection is no longer provided. Call after-sales support.
Important safety instructions before installation.
Critical warning about reversing battery polarity during installation.
Details on performance testing according to IEC 61643-1 standard.
Instructions for connecting devices to UPS power and surge protection outlets.
Guidelines for safe battery handling, service life, and proper disposal.
Diagnosing and resolving typical issues with the UPS system.
Configuring UPS response to AC voltage variations for optimal stability.
Options for deactivating or modifying the UPS audio alarm notifications.
General| Power Rating | 600 VA |
|---|---|
| Output Power | 360 W |
| Battery Type | Sealed Lead Acid |
| Number of Outlets | 4 |
| Topology | Line-Interactive |
| Outlets | IEC 320 C13 |
| Input Voltage | 230V |
| Output Voltage | 230 VAC |
| Data Line Protection | RJ11/RJ45 |
To Next Page