7
Care & Maintenance
Make sure the purifier is turned off and unplugged.
Use a vacuum cleaner or a soft cloth
to remove any dust from the air
inlets or the filter compartment, so
as to ensure optimal ventilation and
purification.
The latch of the particle sensor's
cover is located just above the inside
of the filter compartment. Remove
the cover, by pushing a finger up
against the latch (as shown in
Illustration A).
Use an air blow gun or a hair dryer to
clean the cover and the sensor (as
shown in Illustration B).
Cleaning the filter compartment
Cleaning the laser particle sensor
Note: Do not use hot air.
Illustration A
Illustration B
To Next Page
Loading...
