This version is for private use only and should not be distributed.
Adjust the handlebar
Long-term use of the scooter may result in loose screws, causing the handlebar stem to get unstable. If
you notice the handlebar stem gets shaky when riding, follow the steps below.
Tools:
I: 8-10 mm wrench
II: 4 mm Allen key
Note: These tools are to be prepared by the user.
Steps:
1. When in the folded state (see page 12), use tool I to loosen "c" (clockwise).
2. Use tool I to loosen "b" (clockwise).
3. Use tool II to adjust "a" (clockwise) to the appropriate position, and use tool I to tighten "b"
(counterclockwise).
4. Fold the handlebar stem up, close the quick release lever and turn the handlebar stem clockwise to
close the safety hook.
5. Shake the handlebar stem to see if the problem has been resolved.
If not, repeat step 2 and 3.
If it has, continue to step 6.
6. Return to the scooter to the folded state and use tool I to tighten "c" (counterclockwise).
* Step 6 is mandatory.
a. Inner Hex Nut
b. Hex Stud
c. Hex Nut
To Next Page
Loading...
