NFC: 13.56 MHz < 42 dBuA/m at 10m
5G connection depends on country, carrier, and user environment.
FCC Regulations
This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
This mobile phone has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information (SAR)
This device meets the government’s requirements for exposure to radio waves. This
device is designed and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy. The exposure standard for wireless devices employs a unit of
measurement known as Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/Kg. For body-worn operation, this device has been
tested and meets the FCC RF exposure guidelines for use with an accessory that contains
no metal and positions the device a minimum of
1.0 cm from the body. RF exposure compliance with any body-worn accessory that contains
metal was not tested and certified, and use of such body-worn accessory should be
avoided. Any accessory used with this device for body-worn operation must keep the device
a minimum of 1.0 cm away from the body.
FCC Note
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC
limits.
E-label
This device has an electronic label for certification information.
To access it, please go to Seings > About phone > Certification, or open Seings and type
“Certification” into the search bar.
Model: 2312DRAABG
2312 indicates that this product will be launched aer 202312.
Disclaimer
This quick start guide is published by Xiaomi or its local affiliated company. Improvements
and changes to this guide necessitated by typographical errors, inaccuracies of current
information, or improvements to programs and/or equipment, may be made by Xiaomi
at any time and without notice. Such changes will, however, be incorporated into new
online editions of the quick start guide (please see details at www.mi.com/global/service/
userguide). All illustrations are for illustration purposes only and may not accurately depict
the actual device.
Manufacturer: Xiaomi Communications Co., Ltd.
Manufacturer postal address:
#019, 9th Floor, Building 6, 33 Xi’erqi Middle Road,
Haidian District, Beijing, China, 100085
Brand: Redmi
Model: 2312DRAABG
© Xiaomi Inc. All rights reserved.
To Previous Page
Loading...
