Michelin 27010 - Connecting the High-Pressure Hose

Inflation: the quick release valve (7) can be directly connected to the Schrader Valve by holding the
quick release connector at its base (Fig 1) and pushing the connector firmly onto the valve. While still
pushing forward, slide your thumb and forefinger down into the grey collar and continue pushing
until the collar stops moving forward (Fig 2). A successful connection will result with no air escaping
(hissing) from the valve. If a hiss occurs, remove the connector by holding the grey collar and pulling it
back and try again.
Schrader Valve
CONNECTING THE HIGH-PRESSURE HOSE
Fig 1
Fig 2
To inflate footballs and other balls use the needle adapter. To connect the
needle adapter to the quick release valve connector, push and hold the needle
adapter into the hole of the connector with one hand while holding quick release
connector at its base (Fig 1) push the connector forward. While still pushing
forward, slide your thumb and forefinger down into the grey collar and
continue pushing until the collar stops moving forward (Fig 2). The needle valve
is now locked into the connector. To remove the needle valve, hold it with one
hand and pull the grey collar back with the other hand.
Needle Adapter
Inflation: Screw the Presta Valve adapter onto the cycle tyre valve stem. Then
holding the quick release connector at its base (Fig 1) push the connector
firmly onto the adapter. While still pushing forward, slide your thumb and
forefinger down into the grey collar and continue pushing until the collar stops
moving forward (Fig 2). A successful connection will result with no air escaping
(hiss) from the adapter. If a hiss occurs, remove the connector by holding the
grey collar and pulling it back and try again.
Presta Valve Adapter
ADAPTeRS
Included with your MICHELIN 12v Programmable Tyre Inflator are 3 adapters, to enable you to inflate
other items.
To avoid overinflation, always follow the manufacturer’s instructions on the items to be inflated.
3.