Inflator has been turned
on but will not inflate
Inflator is operating normally
but the digital display shows
zero
For all other issues please call the helpline:
+44 (0)800 731 4973
Slow inflation speed
7.
PSI kPa
10 69
20 138
30 207
40 276
50 345
60 414
70 483
80 552
90 621
100 689
BAR
0.69
1.38
2.07
2.76
3.45
4.14
4.83
5.52
6.21
6.89
CONVERSION CHART
Check if the battery is charged.
Check whether the current tyre pressure is higher than the
pre-set pressure.
Check if the battery is charged.
Check the hose has no air leakage.
Check that the quick release valve connector is correctly connected.
Possible slow puncture.
Sporting goods; footballs, basketballs and other low pressure
inflatable products are not within the measuring range of the
inflator.
Check that the quick release valve connector is correctly connected.
The power indicator, when
running, is inconsistent from
when in standby
This is because the battery voltage discharges during the inflation
process. This inconsistency will not affect the functionally of the
inflator.
The tyre pressure value is
displayed abnormally when
the inflator is turned on
To perform a hard reset: Press the power button for 5 seconds,
OFF will be displayed then turn the jog wheel clockwise 1 click,
000 will be displayed then press the power button to complete the
hard reset.
If this reset fails or there are any other issues contact the helpline
number below.
Trouble shooting
To Next Page
Loading...
