4.
digital display
The digital display (2) is used to set the modes of the inflator, monitor battery power and air pressure
when inflating your desired objects. The inflator is shipped with a protective film over the digital display.
This should be peeled off prior to use to get a clearer view of the display.
When the inflator is switched on and connected to the tyre, the current pressure will be displayed on
the screen. Tyre pressure reading accuracy +/-1 PSI 3 to 50 PSI, +/-2 PSI 51 to 100 PSI, +/-3 PSI 101 to
145 PSI.
To ensure safety, please check the recommended pressures by reading the instruction manual provided
with your vehicle/motorcycle/cycle/inflatable item. Compressed air can be dangerous. Overinflating can
be dangerous and possibly result in injury. Under or overinflated tyres can be dangerous and possibly
result in injury.
PRESSURE INDICATION
CORRECT TYRE PRESSURES
TYRE INFLATION
1. Press and hold the power button (1) for approx. 3 seconds the digital display will illuminate and the
display will default to car mode and the pressure setting (32PSI) will flash 3 times. If these settings
match the requirement needed then simply unclip the high pressure air hose (6) and connect it to the
tyre as instructed on page 3 and press the power button for 1 second to start inflation.
Improper attached hoses or accessories can become detached under pressure and cause serious injury.
Possible air leaks can cause faulty pressure readings. Make sure all connections are tightly secured
before inflating.
The inflator will stop automatically when the selected pre-set pressure is reached. To stop inflation at
any point press the power button (1)
To change the inflation mode and pressure format follow the Steps 2-4 below. Note the inflator must
be on, to do this follow Step 1 above.
2. Press and hold the power button for approx. 2 seconds, the display will change to show just the
car icon and the PSI format (Fig 3).
3. Within 3 seconds of Step 2 turn the jog wheel clockwise to scroll through the 4 mode options (Fig 3).
1 click = 1 mode. Note each mode has the following default pressures:
Jog Wheel
A slow rotation will increase the pressure by +1 PSI/ 0.05 BAR/ 5 kPa
A fast rotation will increase the pressure by +5 PSI/ 0.5 BAR/ 50 kPa
In the mode setting procedure clockwise scrolls through the pressure modes:
Anti-clockwise scrolls through the format settings:
free mode has no icon
The jog (3) wheel allows quick and easy navigation of the inflator functions.
To Next Page
Loading...
