Need help?Do you have a question about the Micro Seiki DD-40 and is the answer not in the manual?
General| Drive method | Direct Drive |
|---|---|
| Platter diameter | 300 mm |
| Speeds | 33 1/3, 45 RPM |
| Cartridge | Not Included |
| Motor | DC Motor |
| Platter | Aluminum |
| Wow and flutter | 0.03% |
| Tonearm Type | Static Balance |
Procedures for replacing the tonearm assembly on the turntable.
Steps for removing and replacing the turntable's main motor.
Guide for replacing the power supply circuit board unit.
Instructions for replacing the power switch assembly.
Steps for replacing speed selection and variable resistor components.
How to adjust the stylus overhang for optimal tracking performance.
Correcting headshell tilt after cartridge replacement or setup.
Balancing the tonearm using lateral weights for proper tracking.
Setting anti-skating force based on stylus type for accurate playback.
Adjusting the arm lifter height for proper automatic operation.
Setting tonearm height for parallel alignment with the record surface.
Calibrating turntable playback speeds via internal variable resistors.
Adjusting the tension of the dust cover hinges.
To Next Page
